KEEMUX-P2 (2-Port PS/2 KVM Switch) INSTALLATION / USER GUIDE MAN049 Rev Date 4/8/2004 K

8 RS232 Interface Test Program RS232 communication is configured using the RMTEST program, located on the supplied floppy disk. This software allo

9 RS232 Port (DB-9 MALE) PIN SIGNAL FUNCTION 1 - No connection 2 RXD Receive data 3 TXD Transmit data 4 DTR Data terminal ready 5 GND Sig

10 SERIAL NO.: DATE: INSPECTED BY:  KEEMUX-P2  KEEMUX-P2-RMT  KEEMUX-P2-AUD  KEEMUX-P2-

WARRANTY INFORMATION The warranty period on this product (parts and labor) is two (2) years from the date of purchase. Please contact Network Tech

1 TABLE OF CONTENTS INTRODUCTION ...

2 FEATURES AND FUNCTIONS 1. CPU Status LEDs- for visual indication of connection between the user and a specifi

3 INSTALLATION 1. Turn OFF power to all CPUs that will be connected to the NTI Switch before connecting or disconnecting any cables. WARNING! D

4Units with audio support (optional) Connect the 3.5mm plug from speakers to the 3.5mm jack labeled "AUD OUT". Attach SA-xx-MM audio ca

5 Keyboard Control In order to control the switch with the keyboard, COMMAND Mode must be enabled. To enter/exit COMMAND Mode from the keyboard:

6Keyboard Features The keyboard configuration of each CPU is saved in the NTI Switch. For example, if the CPU attached to Port 2 had CAPS LOCK and

7ONOFF1 2 3 4 5 6 7 8 Dipswitches The dipswitches located next to