Network-technologies DVB-ASI to IP Manual de usuario descargar pdf (Pagina 65)

ASI-IP-GTW User's Manual

Page 65

The WEB interface gives the most detail alarm information as all active

alarms and warning are listed with time when the alarm condition

occurred.

The unit sends an SNMP trap message when an alarm condition rises.

A critical alarm will have severity level 6 and a warning will have

severity level 3. When the alarm is cleared, a new message is sent to

indicate that the alarm condition is cleared.

Finally, the red alarm LED will illuminate when an unmasked alarm

condition rises. At the same time the alarm relay will be in an alarm

state.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 92 93

DVB-ASI to IP 1
Important notice: 3
About this manual 3
How to use this manual 3
Page 4 4
Table of Contents 5
1 Introduction 8
1.2 Contact Information 9
1.4 Summary of Features 10
1.5 Guided Tour 12
1.5.4 Construction 13
1.5.5 Hardware Options 13
1.5.6 Software Options 14
2 Installing the Equipment 15
2.2.4 Equipment access 16
2.2.5 Ventilation 16
2.2.2 To fix the equipment 16
2.2.3 To cable the equipment 16
2.3 Power 18
+ (positive terminal) 20
- (negative terminal) 20
2.4 Signal Connections 21
2.4.3 Ethernet data port 22
2.5 LEDs 23
2.6 Powering Up/Down 24
3 Operating the Equipment 25
Page 27 27
3.4 Status 28
3.5 Device Info 29
3.5.1 Network 30
Page 32 32
3.5.2 Time settings 33
3.5.3 Alarms 34
3.5.4 SNMP 34
Figure 13 SNMP tab 35
3.5.5 Ping 36
3.5.6 Security 38
3.6 IP TX 39
3.6.2 FEC Settings 42
3.6.3 Ethernet Settings 44
3.6.4 Ping Settings 45
3.7 IP RX 46
3.7.2 FEC Settings 48
3.7.3 Ethernet Settings 50
3.7.4 Ping Settings 51
3.7.5 Advanced Tab 52
3.8 Network 54
3.9 Save/Load 56
4 Options 58
Figure 31. GPS tab 59
4.1.4 LED descriptions 60
4.2 RIPv2 functionality 61
5 Equipment Description 63
5.2.3 IP Receive Mode 64
5.2.4 IP Bi-directional Mode 64
5.2.5 Management 64
5.2.6 Alarms 64
Page 66 66
5.3.1 Protocol mapping 67
6.1 Introduction 70
6.2 Preventive Maintenance 70
6.3 Maintenance 70
6.4 Fault-finding 71
6.6 To return the unit 75
7 Appendix A: Glossary 76
8.1 DVB ASI port 80
8.2 Ethernet data port 81
8.5 AC Mains Input 82
8.6 DC Mains input 82
8.7 Physical Details 83
8.9 Compliance 84
8.9.3 CE Marking 85
9 Appendix C: References 86
Figure 40 Upgrade SW 90
Figure 41 SW load progress 91
Figure 42 SW load status 91
Packet priority 92
12.3 Layer 2 priority 93

Comentarios a estos manuales

Sin comentarios

Network-technologies DVB-ASI to IP Manual de usuario Pagina 65

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Network-technologies DVB-ASI to IP