Network Technologies 900GV Manual de usuario descargar pdf (Pagina 43)

Configuring the Module in a DIGITAL MultiSwitch 900 4-9

[4] Configure IP

This option provides you with IP configuration selections.

NOTE

For any of the IP Configuration menu options to take effect, the module needs to

be reset. Use [2] Restart with Current Settings from the

VNswitch 900GV INSTALLATION MENU. Allow approximately 1 minute

for the module to restart and complete self-test. (Because this option restarts only

the module, and leaves storage parameters configured at their current values, the

module’s restart process takes only 1 minute.)

The following example shows the dialog associated with this option:

The following pages describe the IP Configuration options:

Topic Page

[1] Set SNMP Read/Write Community 4-11

[2] Add SNMP Trap Addresses 4-12

VNswitch 900GV - slot 3

=========================================================

IP CONFIGURATION

[1] Set SNMP Read/Write Community

[4] Set In-Band Interface IP Address

[6] Set Default Gateway

[7] Return to Main Menu

Enter selection number : n

[5] Set Out-of-Band Interface IP Address

* * * * * * * * * * * * * * * * * * * * * * * * * * *

* Configuration will not take effect until module is *

* restarted. *

* * * * * * * * * * * * * * * * * * * * * * * * * * *

=========================================================

[3] Delete SNMP Trap Address

[2] Add SNMP Trap Address

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 71 72

Sin comentarios

Network Technologies 900GV Manual de usuario Pagina 43